Видео

Whats the part number on bottom piece my hose is just barely fitting over the y piece

😂 bullshit

I wish you would have showed the part when you were actually pushing them on is it easy to just push them on?

👍

It's still 4" the exterior is 5" but the internal is the same size as the 4"

And never get it registered in az again

This video just saved me a thousand dollars in labor alone. You made it look easy and it was pretty easy. Thanks.

Eazierrr…..

Thanks bro, 👍🏿 great explaining and details

Guys don’t do this you lose power

Hey bro I just found this gonna use it on my wife's 06 that I'm seeking to my Best friend. Thanks uso I really appreciate this video

Nice I’m actually gonna have to do that. I had my bolts on my calipers get stuck and I’ve literally destroyed my sockets my wrenches and that wrench you used to pull that pen out and my mind was just blown. I was like how do I even fix this I gotta buy all new tools And have an alternative to that so now I’m just gonna put a piece of tape around it and I’m gonna put grabber so I’ll remember what I’ll use that for

I have an sr20 p11/G20 that's done over 430,000 k's I think that's nearly 280,000 miles and it still goes hard and starts almost instantly every time

Great informative upload. Your knowledge and experience is very much appreciated. Keep informing the people...

I ran pure water in summer never rusted up the engine I don’t recommend that for everyone but these 6.0 are pretty tough I was only running water due to slow leak in the radiator but I also own 4 cat eye 2500hds so don’t care if it blew up I’ll swap the engine lol but when I tore It down building it no rust so don’t worry to much about water in there, but get the green out of there the vortecs really do better with dex

I have a code P0735. Do you think this is the issue? It shifts fine until it’s time to shift into 5th gear

Too bad they only fit rwd

My check engine turned on after I put test pipes on

Good job.

Great vid , but heads up to everyone else you could remove The coils after you take the intake off especially on the left side it’s way too crowded there

so you got stillen exhaust and took off mufflers?

I appreciate this video

On the 08 civic which 02 sensor gets the spacer?

I have a 2012 G37x with a bashed in rear passenger door, the cheapest replacement I can find is $600. I love this car but $600 bucks is a bit much for a 12 year old door.

That's a nice QX4, I have a 2001 with 89,000 miles on it. ( non 4x4) In the three years I've owned it it has given me no problems, except the sunroof is leaking and every body shop I've gone to told me it has to go to the dealer to get it replaced. Other than that these are great vehicles.

And all this is on top of the oil pump and timing chain replacement and I tried starting it after that and found the fuel filter was clogged and starved the pump because the fuel pump was on a angle and letting dirt down in the tank for God knows how long 😢

But my delima right now is three of the 4 tangs that secure the pump in place are rusted off and I'm searching for a solution right now

Or you can cut a access panel in the bed which I'm so glad that I did because I'm putting in my 4th pump right now 😢

you don't you have to pull a vacuum??

I really appreciate this video. It was the only one we could find that helped. We got everything on okay, no leaks but still not working. There's a chance we might have reversed those two little lines held on with hose clamps. Does it matter if we did? Don't know if you're still around but, again, thanks for the video.

Hey Eric, Props to you. My Silverado wouldn't fire yesterday, and I suspected the fuel pump. After a couple tests it was pretty much the only thing it could have been. Looked up changing a 2001 Silverado fuel pump, watched your video once, bought a new pump and have my truck running this evening. Thanks much!!!!!!!!!

I tried changing mine but one the screws wouldn’t go in, any help?

Been smacking my starter for a month because if I take it out the flywheel will fall out, (the truck was never taken care of and nothing was ever changed in it)

Its actually kind of disturbing how easy the tailgate comes off.

What can it be if it doesn't spin at all?

The video wack

thank you Bro

Respect how professional he sounds and user friendly you are. Had to comment and give props!

Where are they made from?

Hi, may I know what thickness of the rear hub spacers?

Thank you!!!!!!! Your video is the only one that keeps it real and straight to the point and no bull!!!! Other guys on here will tell you to take off the wheel and make so difficult to take the starter out of its place. Thank you!!!!!!!!🎉

That wasn't stuck. It rotated easily. How do you free one that is actually stuck?

You make claim to a hollowed cat for the purpose of higher HP, and yet you have no proof one way or the other. That is to say, your words are 100% speculation. And that is where the video below steps in. Putting facts in place in place of opinion. ruclips.net/video/Ulw0UX3iPm4/видео.html

Lucky You :) If only they came off that easy even with a breaker bar

Dude this was very helpful wish I watched before buying the tools but now ik what I need lol

Thank you so much for this video. My PSF is starting to leak as well. I know its an old video but did you find out where in the hose did it leaked?

Where is the 2015 Kia Sorento MAF located?

Hi man, great video 👏👏.. I also have 350Z 2008 which has the same engine Same Compressor. I want to replace the AC compressor but do you have any idea how much Pag Oil I need to add to it? I'd really appreciate your help. Last year my new Compressor blew up mostly due to the wrong amount of Pag Oil which was added to it. If you have any idea or can help I will be grateful.

That was a awesome job and I enjoyed how you were very helpful on all the tricks and techniques on this ! Thank you!

Your video helped me a lot! Now my G35 doesn't leak oil every time I turn the steering wheel.😅 Now I will be using your video to replace the valve covers with the aluminum ones from MITZONE, I hope it works well.